I had had some sleepless nights thinking through the truss designs and plotting my lifting contraption.
Fitting roof truss clips.
I fixed each truss to the wall plates with galvanised truss clips.
This video illustrates each step in safely erecting roof trusses as well as related topics like risk management falls protection and manual handling.
For example when setting trusses you will rest each of the two ends of the truss onto opposite walls which have wall plates at the top of each wall.
Truss clips and framing anchors in timber roof construction the timbers trusses or rafters need securing to the wall plate.
Pull the tape measure along the length of your roof and climb up the ladder in the new position to take your measurement.
Hurricane roof clip installation hurricane tie down installation roof truss strap installation wind mitigation inspection.
Insert a 6 cm 3 1 2 inch nail through the truss base where it sets on the wall plate.
Use katz blocking at 4 o c.
Insert the pre cut structural blocking to fit securely between the underside of the floor ceiling joist or roof trusses.
Get off of your ladder and reposition it at the other end of your roof.
They are relatively inexpensive and if you want to install them by yourself then they just require a little bit of care and attention.
Use a tape measure to find the length of your roof.
This can be done by skew nailing on all form of roof but on trusses or trussed rafters there is a danger of skew nails disturbing the joint or themselves being deflected by the plates or connectors resulting in an.
It was an even bigger relief that they fitted because there isn t much you can do to a pre made truss if it doesn t.
Our third nail system is significantly stronger than the dual nail roof truss straps systems typically used and as a result will save you 25 to 30 percent on your homeowner s insurance premiums.
Make sure that the roof truss is aligned properly on each side of the wall plates.
Using 8 minimum self drilling screws secure the blocking to steel framing of 8d nail to wood framing using the pre punched holes.
Climb a ladder near the corner of your roof and tape the end of your tape measure against the rafter using duct tape.
These clips work by further strengthening the bond between the roof and the walls of your house so the roof does not blow away in a hurricane.
.jpg)
